Dometic PerfectView CAM 440 – Near and Far View with a Single Camera Lens
The Dometic PerfectView CAM 440 is a compact dual-vision reversing camera for motorhomes, vans and trucks. It combines two different viewing modes in a single camera lens: a wide-angle near view for manoeuvring and reversing, and a zoomed far view for monitoring the area further behind the vehicle.
The CAM 440 is particularly useful for larger vehicles with restricted rearward visibility. Its compact ball-shaped design allows installation in various positions, including at the rear of the vehicle.
Two Viewing Modes for Different Driving Situations
Depending on whether reverse gear is engaged, the CAM 440 provides different views:
-
Near view: When reverse gear is engaged, the wide-angle rear view is activated. With a diagonal viewing angle of 172°, it provides an overview of the area immediately behind the vehicle.
-
Far view: Outside reversing operation, a zoomed view is available. Its diagonal viewing angle is 105° in AHD mode or 98° in CVBS mode, allowing more focused observation of the area further behind the vehicle.
Both views are generated by the same camera. A second camera is therefore not required for the basic near and far view function. Actual display behaviour depends on the installation and monitor control configuration.
AHD and CVBS – For Different Monitor Systems
The CAM 440 supports AHD and CVBS (PAL) video signal formats. This allows it to be used with suitable high-resolution AHD monitors as well as conventional PAL monitors.
The video signal format is selected during installation using a cable loop. With the blue cable loop closed, the factory setting is CVBS. For AHD operation, this loop must be cut according to the installation instructions.
A six-pin Dometic monitor connection and an RCA video output for suitable universal monitors are provided. The image can also be configured for mirrored or non-mirrored display.
Important: Before connection, check the supported video signal format, connector pin assignment and, where applicable, the power supply requirements of the monitor. Support for a particular video format alone does not guarantee full connection compatibility with every monitor model.
Compact Design with Integrated Microphone
The ball-shaped camera has a diameter of approximately 36 mm and can be adjusted within its mounting bracket after installation. Its integrated 2-megapixel CMOS image sensor supports output in AHD or CVBS format. With a light sensitivity of less than 0.5 lux, the camera is designed for use in challenging lighting conditions.
An integrated microphone allows audio transmission to a suitably equipped monitor system. The camera housing meets the IP69K protection rating and is designed for outdoor installation on vehicles.
Expandable with a Control Switch and Second Camera
The CAM 440 basic kit is designed for future expansion. Two optional accessories provide additional functions:
-
Dometic CAM 440CS control switch (manufacturer part no. 9620013722): Allows manual switching between near and far view independently of the automatic gear-dependent selection.
-
Dometic CAM 440E additional camera (manufacturer part no. 9620006605): Allows an additional vehicle area to be monitored, for example at the rear, along the side or inside the vehicle. Switching between cameras is performed using the optional control switch.
Please note: The CAM 440CS control switch and CAM 440E additional camera are sold separately and are not included in the CAM 440 basic kit.
Scope of Delivery
- 1 × Dometic PerfectView CAM 440 camera
- 1 × 20 m system cable
- 1 × 5 m extension cable
- 1 × camera-side Y adapter
- 1 × monitor-side Y adapter
- Mounting hardware
- Installation and operating manual
Note: The reversing camera is a driver assistance system and does not replace the driver's attention and responsibility. Installation and electrical connection must be carried out in accordance with the Dometic installation and operating manual.